Warning

You are reading the documentation for an older Pickit release (3.2). Documentation for the latest release (3.4) can be found here.

Fixed camera cable

The fixed camera cable is a 10-meter USB2 cable, and is indended for use with fixed camera mounts. It has a type-A USB plug on the processor side and an 8 pin M12 screwing connector on the camera side.

This cable is compliant with the Electrical Fast Transient (EFT) - IEC/EN61000-4-4 immunity standard. More details of the mechanical and electrical characteristics of this cable can be found in the datasheets of the SD Pickit cameras.

../../../_images/fixed-camera-cable.jpg

Installation

As a pre-requisite, mount the camera to its supporting structure, following the best practices.

Connect the 8-pin connector to the camera, and the type-A USB connector to the Pickit processor, in one of the USB ports labeled CAMERA. To correctly connect the 8-pin cable connector, you should:

  • Turn the connector nut to align the mark with the connector body.

  • Insert the connector on the plug.

  • Tighten the connector nut half a turn until it clicks.

A continuous green LED on the front of the camera confirms when it’s powered.

../../../_images/connect_fixed_camera_cable.png

It is also recommended to add a strain relief close to the camera connector. It prevents cable stress from reaching the camera.

../../../_images/strain_relief.png